Some of my Project Highlights in brief:Project:1 Design of Vortex Tube• Final Year Project on “Design of Vortex Tube”Work Details: Pressurized gas is injected tangentially into a swirl chamber and accelerated to a high rate of rotation. Due to the conical nozzle at the end of the tube, only the outer shell of the compressed gas is allowed to escape at that end. The remainder of the gas is forced to return in an inner vortex of reduced diameter within the outer vortex.Project:2 Hand-Injection• Manufacturing of Hand-Injection mould @ CTTC, BhubaneswarWork Details: In this method, the type was made by punching a letter-shaped cavity in a matrix made of some soft metal (typically copper). Then this matrix would be held in the lower part of the mould, the upper part would close on it, and molten type metal would be poured into the cavity. Using the hand mould, the printer could quickly make any additional type.