Looking to put my 18 plus years of mechanical design experience to good use on a part-time basis and help you out where I can. I'm not and Engineer by trade, so I will not be able to give any engineering advice. By trade I utilize Pro Engineer to develope sheet metal parts, some plastice parts, mechanical parts and tubing. The services I can offer you are as follows, but not limited to: I can take your sketches and turn them into 3D parts, sub-assemblies, final assemblies and create 2D drawings of specific parts to be manufactured, exploded assembly drawings with BOM's...ect I'm proficient in sheet metal layouts, flat patterns (along with DXF's) and can create drawings for manufacturing. I can also create fixtures for sub-assemblies if needed. I'm also proficient in Pro Piping as it pertains to HVAC products, but can use Pro Piping in other areas. These are just a few areas I may can assist in.