About:
10+ years Experienced Mechanical Engineer with experience in Oil and Gas, Power and Chemical industry.
Career Summary:
Well experienced in Piping Stress Analysis and Pressure Vessel Design.
Experienced in Onshore and Offshore Projects; Can handle both Greenfield and Brownfield projects;
Specialized Experience:
1. Engineering Design (Piping Stress Analysis)
2. Cost Optimization (Pipe Supports and Routing)
3. Quality Assurance (QMS and Client Requirements)
Codes and Standards
Well versed with ASME B31.3, ASME B31.1, ASME B31.8 and ASME B31.4. ASME B16.5 and ASME B16.9;
Knowledgeable in Piping related DNV (DNV-OS-F101) and API cods.
Well conversant with WRC 107/WRC 537, API 610, API 650, DNV RPs, Shell DEPs, PED
Software Skills:
1. CAESAR II and AutoPipe
2. PV Elite
3. FE SIF and FE Bend
4. Navisworks Review and Smartplant Review
Piping Stress Analysis Capabilities:
1. Piping Stress Analysis of lines connected to Pumps, Heat Exchangers, Tanks, Column lines, Air Fin Cooler Inlet and Outlet Lines, Pipeline-Piping Interfaces and other static equipment for offshore and onshore projects
2. Performing Fatigue Analysis for thermal cycles and Wave cycles for offshore project
Analysis of Two-Phase flow lines and Slug flow lines
3. Preparation of Critical Line List and Stress System Classification
4. Control and Optimization of Piping-Supports using Material Control Management System software
5. Inter Discipline Information Transfer of Piping loads to Civil
6. Inter Discipline Check of Structural design as per Stress Requirements
7. Piping Tie-in Engineering for Brownfield Project having 1200 Tie-ins
8. Review of the 3D Model for 30%, 60 % and 90 % Client Model Review readiness
Pipe Supports Engineering:
1. Selection of Supports based on load capacities, MOC, line Size and temperature
2. Preparation of technical specifications for Specially Engineered Pipe Supports like Spring Hangers, Expansion Bellows, Rigid Struts, Rod Hangers, Low Friction Slide Plate Assemblies
3. Vendor Document Review and Technical Bid Evaluation of Specially Engineered Pipe Supports
4. Design Special Supports which fall outside scope of Support Standards
5. Pipe Support MTO (Preliminary, Intermediate and Final)
Pressure Vessel Design Capabilities:
1. Pressure vessels (Scrubbers, Surge drum, Overhead drum, Air receivers, Reactors, Gas Boot, Tanks and Process columns) along with instruments and Isolation Valves,
2. Heat Exchangers (Fixed, U-Tube , Floating, Stack Type),
3. Skid Packages (Indirect Water Bath Heater, Heater Treater, Desalter, Steam Exchanger and Three / Two Phase Separators) for Onshore and Offshore,
4. Boiler Package - Fire Tube as per ASME Section I and Section VIII Div.1,
5. Filter Package (Coalescer, Filter Water Separators, Micro Filter, Clay Filter, Carbon Filter)
6. Fiber Reinforced Plastic Storage Tank, Scrubbers and Vessel as per BS-4994,
7. Pressure vessel designed & reviewed as per EN13445.